Application of the irrigating solutions and bonding procedures The coronal dentin of the control specimens were restored directly without the use of the different irrigants. A single-step self-etching adhesive, Clearfil S3 bond in a single-dose form, (Kuraray Medical INC, Okayama, Japan. Lot # 00007B) was applied according to the manufacturer��s selleck inhibitor instructions. The self-etching adhesive was applied with gentle agitation using the supplied micro-brush and left undisturbed for 20 seconds. The adhesive was then air-dried with high pressure oil-water free compressed air for 5 seconds and light cured for 10 seconds using a halogen light curing unit (Cromalux-E, Meca-Physik Dental Division, Rastatt, Germany) with an output of 600 mW/cm2. The experimental specimens were irrigated with 10 ml of each irrigant for 20 minutes.
The solution was renewed every 2 minutes so that the dentin surface was kept moist throughout this period. After being rinsed with 10 ml distilled water, half of the specimens received immediate adhesive application as for the control specimens, while the other half were sealed with sterile cotton and a temporary restorative material (Coltosol, Coltene G, Altsatten, Sweitzerland) and kept in an incubator in 100% relative humidity at 37��C for one week. After this period the temporary restorations were removed, the specimens were rinsed using copious air/water spray for 10 seconds and gently air dried for 5 seconds, before the application of the adhesive. The adhesive was applied as mentioned before. The irrigation and bonding procedures are summarized in Table 1.
Table 1. Summary of irrigation and bonding procedures. A transparent polyvinyl tube (3 mm in diameter and 2 mm in length) was filled with resin composite material (TPH? Spectrum, Shade A3, DENTSPLY, Konstanz, Germany, Lot # E617014), placed over the cured adhesive, and the composite material was cured for 40 seconds. After curing of the composite material, the polyvinyl tube was cut using bard parker blade #15 and the specimens were stored in distilled water for 24 hours. Shear bond strength testing For shear bond strength testing, 8-specimens form each group were used. Each specimen was mounted to a universal testing machine (Lloyd Instrument LR5K series- London, UK) and a chisel bladed metallic instrument was positioned as close as possible to the composite/dentin interface from the occlusal enamel side, in which no artificial acrylic wall was present (Figure 1C).
The test was run at a crosshead speed of 0.5 mm/minute until failure. The load recorded in Newton was divided over the surface area and the shear bond Drug_discovery strength was calculated in megapascal (MPa). Figure 1C. Schematic diagram represents the direction of the applied shear force from the occlusal enamel side using the metallic chisel bladed instrument. SEM preparation For SEM evaluation, 2- specimens were used from each group.
Related posts:
- Resources and procedures All animal experiments were performed on
- 4��g/mL solutions (A2/A0 4) was calculated by the mean values of
- 10 Problems And Solutions To ZM-447439 LY294002 cancer research
- These procedures were done in an work to clarify their potential
- Such an approach has already been taken for the prognostication o