Each NP deposits/substrate combination was prepared by pipetting NPs suspensions (approx. 30 ± 0.9 EPZ015938 μL) onto the substrates with subsequent spin-coating at 500 rpm for 3 s and then 2,000 rpm for 15 s. In situ high-temperature synchrotron radiation X-ray diffraction (SR-XRD) was performed at the wiggler Vorinostat concentration beamline BL-17B1 of the National Synchrotron Radiation Research Center (NSRRC), Hsinchu, Taiwan. The incident X-rays were focused vertically by a mirror and monochromatized to 8 keV (λ = 1.5498 Å) by a Si(111) double-crystal monochromator. In this experiment,
two pairs of slits positioned between sample and detector were used, which provided the typical wave vector resolution in the vertical scattering plane of about 0.003 nm-1. The temperature-dependent XRD patterns of all the samples were collected on a resistive heating copper stage at a heating rate of 5°C/min in air. To minimize the collection time, the patterns were collected only in the 33° to 43° 2θ range back and forth at a scan rate of 5°/min
and the evolution of the diffraction peaks was monitored simultaneously. The surface morphology observations were performed by scanning electron microscopy (SEM, JEOL JSM-6460, Akishima-shi, Japan). The chemical valence states of the elements on the surface of the NP deposits were examined using X-ray photoelectron Selleck CRT0066101 spectroscopy (XPS) with Al sources. To evaluate the electrical performance of the NP deposits, four-point probe measurement of the deposit resistivity after being heated to different temperatures was performed. The corresponding optical absorption properties were also examined using a UV-vis spectrophotometer. Results and discussion Characteristics of nanoparticles If we take the Ag, AuAg3, and Au nanoparticles as examples, the TEM micrographs of the as-prepared thiol-protected nanoparticles (Figure 1a,b,c) show a close-packed arrangement. As revealed in Figure 1c, some of nanoparticles
are heavily twinned. Quantitative data given in Figure 1d indicate that the average core diameter of the nanoparticles Phosphatidylethanolamine N-methyltransferase was 3.6 nm for Au, 8.1 nm for Au3Ag, 7.1 nm for AuAg, and 6.5 nm for AuAg3. Two batches of Ag NPs were prepared and the particle diameters were 8.2 and 10.7 nm, respectively. The compositional feature of the NPs can be identified from the absorption spectra shown in Figure 2. The alloy formation is inferred from the fact that the optical absorption spectrum shows only one plasmon band. As illustrated, the absorption peak was 520 nm for Au NPs. The plasmon band is blue shifted with an increasing content of silver, and then reached 441 nm for Ag NPs. This tendency is identical to those reported in the literature [27–30]. Figure 1 TEM images of nanoparticles (a) Au, (b) AuAg3, and (c) Ag, and (d) core diameters of the nanoparticles used.
Related posts:
- Large-scaled composite hydrogels (several
centimeters) ha - The fragility of the MIFs allowed cleaning the glass surface from
- N-[(3-trimethoxysilyl) propyl] EDTA trisodium salt (50% in water)
- Lipid Histochemistry Glomerular lipid deposits were scored in 4-p
- 2003b, 2008, Krężel et al 2008, Krężel & Paszkuta 2011) Calcula