Figure 6a shows the typical CV curves of the NCONAs electrode with various sweep rates ranging from 2 to 40 mV s-1. The shape of the CV curves clearly reveals the pseudocapacitive characteristics. Specifically, a pair of redox peaks can be observed within the potential range from -0.2 to 0.6 V (vs. SCE) for all sweep rates, which is mainly related to the faradaic redox reactions related to M-O/M-O-OH (M = Co and Ni MDV3100 supplier ions) in the alkaline electrolyte (Figure 7), as shown in
the following equations [32–34]: (1) (2) Figure 6 Cyclic voltammograms, charge discharge curves, and specific capacitance of NCONAs. (a) Cyclic voltammograms of NCONAs at different scan rates. (b) Cyclic voltammograms of the different electrode materials at 20 mV s-1. (c) Charge
discharge curves of NCONAs at various current densities. (d) Current density dependence of the areal capacitance (right) and Selleckchem PP2 specific capacitance (left) of NCONAs. Figure 7 Schematic IACS-10759 cell line diagrams showing the kinetic advantages of the hybrid array in electrochemical energy storage. The peaks are located at around 0.05 and 0.25 V (vs. SCE) when the scan rate is 2 mV s-1. With the 20-fold increase in the sweep rate from 2 to 40 mV s-1, the position of the cathodic peak shifts from 0.05 to -0.15 V (vs. SCE). This indicates the low resistance of the electrode because of the conductive carbon cloth substrate [19]. For comparison, the CV of the pristine carbon cloth and NCONAs electrode at 20 mV s-1 are also shown in Figure 6b. It is noted that the area of the curve of the NCONAs electrode at the same scan rate is higher than that of the carbon cloth electrode materials. The significant increase of the CV integrated area suggests that the nanoneedle-like NiCo2O4 arrays have a much higher specific capacitance, as will be discussed. Therefore, the excellent electrochemical
capability Vasopressin Receptor of NCONAs may be attributed to their unique microstructures. From the constant current discharge profiles (Figure 6c), it can be observed that there are voltage plateaus at around 0.2 to 0.15 V (vs. SCE), which is consistent with previous literature [22, 35]. Specific and areal capacitances were calculated using Equations 3 and 4, respectively. (3) (4) where I (mA) represents the constant discharge current, m (mg), ΔV (V), and Δt (s) designate the mass of active materials, potential drop during discharge (excluding the IR drop), and total discharge time, respectively. S is the nominal area of CC covered with NCONAs (about 5 cm2). The calculated areal capacitance as a function of the discharge current density is plotted in Figure 6d. On the basis of the above results, the specific capacitance of the NCONAs at 2, 4, 8, 12, and 16 A g-1 is 660, 600, 560, 480, and 384 F g-1, respectively. About 58.2% of specific capacity was retained when the current density increased from 2 to 16 A g-1.
Related posts:
- (b) Plots of specific capacitance and its retention ratio vs vol
- Figure 3D�CG shows that a nuclear CD44/STAT3 signal was required
- In order to further testify the existence of the
carbon l - In plots of power spectral density (Figure 2C), each rat had peak
- 75; CI 0 666 – 0 846; P < 0 001) The ROC curves for these variab